Solution Welding Flux-Cored Rods


Trust badge

All you need is a simple propane torch and some easy welding rods!!!

Every aspect of Solution Welding Rods is designed for the pursuit of performance to be the world's best in class in Aluminum and other non-ferrous materials repair.

Solution Welding Flux-Cored Rods 🔥SALE 50% OFF🔥


  • The easy-to-melt welding rods are high-quality special rods that are mainly used for welding / brazing aluminum and aluminum alloys. However, they can also be used for hard welding non-ferrous metals other than stainless steel.

Solution Welding Flux-Cored Rods 🔥SALE 50% OFF🔥

  • Recommended for welding aluminum alloys: 1060 1350 3003 3004 3005 5005 5050 6053 6061 6951 7005 and cast alloys 710.0 and 711.0

  • Applications include cargo areas loading ramps docks diamond plates irrigation lines engine blocks gearboxes etc.

Solution Welding Flux-Cored Rods 🔥SALE 50% OFF🔥

  • Prepared for small repairs. For repairs that would compromise safety if they are not repaired, we recommend replacing the parts completely instead of repairing them.

Solution Welding Flux-Cored Rods 🔥SALE 50% OFF🔥

Welding Instructions:

  1. Through physical cleaning polishing the surface cleaning the grease on the surface of the weld and using a steel brush or copper brush to remove the plating layer etching paint oil oxide and other coatings.
  2. Heat the surface of the base metal at the welding place (do not directly burn the electrode) until the temperature reaches 550 degrees the working temperature of the welding wire. When the surface temperature of the base metal is sufficient the welding wire can flow and penetrate the Jinzhan capillary well.
  3. When repairing thin aluminum parts just heat the aluminum base material to a suitable working temperature and then use the welding wire to friction and fuse to form a weld. Only the gold high brush melted welding wire is used to fill the weld to form a weld.

Solution Welding Flux-Cored Rods 🔥SALE 50% OFF🔥


  • The surface of the base material must be cleaned and dried that is clean and welded
  • The temperature of the base metal must reach 550°C including the temperature of the base metal during the welding process should be kept at about 550°C.
  • Never apply heat directly to the rod as it will crumble and if you manage to melt the rod directly the weld will be easily breakable. Remember melting the rod directly is the wrong way and makes crumby welds


  • Material: Al-Si Alloy
  • Melting point: 400°C (°C)
  • Working temperature: 400¡æ-450¡æ
  • Uses: aluminum welding
  • Size: 19.6 x 0.06in / 50cm x 1.6mm. ( According to the manual measurement there may be a subtle deviation. )


  • 20/40/60/100 pcs * Welding Rods


Return & Warranty
  • 100% Secure payment with SSL Encryption.
  • If you're not 100% satisfied, let us know and we'll make it right.